![]() Read this post before and any relevant guide before asking a question. Slide=0 leads to catastrophe! Use the Clover installer (not Clover Configurator) to install EmuVariableUEFI-64.efi,ĪptioMemoryFix-64.efi, and click the option to Install RC Scripts to Target Volume.Building a CustoMac Hackintosh: Buyer's Guideīefore asking a question, many common questions are already commonly asked and answered, and many answers exist in the sticky threads in this forum. The key is to enable the slide=0 > field in Clover Configurator boot options and install EmuVariableUEFI-64.efi. I will update the EFI folder with my current one at some point (probably).ġ2-07-2018: Thanks to this post by both Shutdown and Reboot are finally working. In order to get NVRAM working properly, follow the following steps here.Thunderbolt 3 (including charging and hotswapping).USB 3.0 / 3.1 (including charging and hotswapping).Shutdown / Restart / Sleep (including bluetooth-on-wake).Audio (except the rear IO's 3.5mm jack.Bluetooth / WiFi (Fenvi T919 PCI/E card - the embedded one is diabled).Working (incomplete list, only the things I care about) You may wish to revert to the standard theme or apply your own. Then, go up to the top and click boot with selected options. ![]() This can be done by pressing the Space button on your keyboard in the Clover boot menu while (make sure you have the installation drive selected), and then selecteding -v in the middle of the argiments list.Add -v to boot arguments to boot via verbose mode until you're positive you have a good setup, instead of showing the logo.Install Catalina using AFPS and not using MacOS Extended Journaled.I know everyone elese says to enable it, but it seems as though Catlina doesn't like it. Please ensure that youhave Chipset > Internal Graphics disabled.If you're doing it manually, you'll see the values have been replaced with the text. This will auto-generate all the information you need. You may do this by visiting the SMBIOS tab and clicking the dropdown underneath "Check Coverage" to the right of the page, and selecting "iMac19,1".Ensure that you visit the SMBIOS in Clover Configurator pane and add your own Serial Numbers. ![]() Either look through the respective folders and manually download and replace the new versions, or point the Clover COnfigurator at the directory and pull them through the UI. While this EFI is still what I use every day, you need to keep your Kexts and Drivers updated! The versions shipped with the EFI don't work with the latest versions of Catalina (10.15.2 (19C57) at time of writing). All kexts and drivers are kept in the EFI folder.īefore You Boot: Grab updated Kexts and Drivers! You can see those steps here: #1 (comment) General Information I documented the general steps you need to take to get a Hackintosh working with this EFI. I've posted an OpenCore version of this EFI that you can find here. Gigabyte Designaire Z390 - for macOS Catalina 10.15 (19A602) UPDATE: It takes quite a bit more configuration than Clover does on Z390 boards, but lucky for you I've already dealt with that pain. OpenCore is generally much faster and cleaner. If you have modeled your system after mine, I suggest using my OpenCore EFI instead. IMPORTANT UPDATE As of macOS 10.15.5 I no longer suggest using Clover
0 Comments
Leave a Reply. |