![]() Nodes must be added in this case as described above. You may wish to create another audio track when you could put some 'atmosphere' sound to cover the 'hole'. Then drag down the two inner nodes, so that line is taken to the bottom of the audio track. Please note this does not work for stereo pairs. Go into the audio tab, right click on the white audio level line and put two nodes before and after the bleep. In the example below the end of the track has been right clicked and held down and the mouse moved left to create fade. Right Click while over these and move the mouse to create a fade. Fading in/Out at beginning/end of eventĪt the beginning and end of the event there is a small grey triangle. Ungrouping Audio Tracksġ) Select options/Coss Icon top/right of Stripview.Ģ) From 'Edit Commands' list select 'Ungroup tracks' (below 'Group Tracks').ģ) Ctrl + mouse click on the Tracks you want to ungroup and click OK. This simply groups them in the current Stripview. You can group two tracks together in Stripview byġ) Select options/Cogs Icon top/right of Stripview.Ģ) From 'Edit Commands' list select 'Group tracks'.ģ) Hold down Ctl and click on the tracks you want to group with the mouse to select them. In the example the tracks have been grouped as a stereo pair so nodes are automatically added to both tracks. Right clicking on the audio level line and moving the mouse adds nodes and changes levels. Adding Nodes to allow audio to be changed during event If you select 'Post Levels' this shows them afterwards. If you select 'Pre Levels' that shows the waveform before effects are applied. Turning on and off mute sometimes solves issue but ended up turning off 'enable clip' to get it to mute reliably. The image below shows how to turn them on:ġ) Click on the Cog icon to show Stripview PropertiesĢ) Click on the Dropdown right of 'Show Audio Waveforms'. Sun 6:24 pm Using the latest version 17.2 and have noticed track audio still playing at times when muted. Fading in/Out at beginning/end of event Showing Waveformsīy default waveforms are not shown.
0 Comments
Leave a Reply. |